DB하이텍의 0.11um ~ 90nm Mixed Signal 공정은 World best Low noise 특성을 보유하고 있으며, Audio Codec, Touch sensor controller, Sensor ROIC 등에 최적화된 공정입니다. 10년 이상의 풍부한 양산 경험을 바탕으로 매우 우수하고 안정적인 Yield (공정 control)를 유지하고 있습니다.

RF 공정은 고객의 니즈에 따라 Bulk (10ohm), HRS (high resistivity substrate, >1kohm), SOI (Silicon on insulator) 등 다양한 옵션을 제공하고 있으며 RF front 응용 (TV Tuner, Bluetooth, Switch, LNA 등)에 맞춰 가격 경쟁력과 특성을 고려한 최적의 선택을 할 수 있습니다. DB하이텍의 RF 공정은 급격히 성장하고 있는 5G 시장 진입을 위한 최적의 solution이 될 것입니다.


0.11um Digital + Analog
- 0.13um channel length with 0.11um shrunk BEOL
- Support Various Vop (1.0, 1.2, 1.5, 2.5, 3.3, 5V)
- ULP (Ultra Low LKG + Low Noise + Low Op.)
(TS11 Process)
  ∙ Optical Shrink Process (90%) of 0.13um Foundry General Process
  ∙ eNVM : ~32bit Poly fuse, ~512Kbit EPROM (eMemory), ~128KbitAnti fuse (Kilopass)
  ∙ Digital IP/Lib : Multi Vth Std. Cell Lib, IO Lib, Memory Compiler
  ∙ SPICE model including Mismatch & Noise, Cadence PDK
(ULP11 Process)
  ∙ Focus on Low Power + Ultra Low Leakage + Low Power Operation,
    Able to Minimize both Active Power Consumption and Leakage in off-status in one technology
  ∙ PNO gate oxide is used for lower 1/f noise
  ∙ 1.5V Low Power & 1.2V Ultra Low LKG.

0.11μm RF Bulk CMOS
- RF process compatible with optical Shrink Process (90%) of 0.13um Foundry General Process
- Substrate resistivity: 10ohm-cm
- Up to 1Poly 5~8Metal process (with UTM)
- Fully Characterized PDK and Industry Standard CAD Tools
- Inductor : Standard, Symmetric, Symmetric with Center tap.
 
0.11μm RF HRS CMOS
- RF process (1.2V / 2.5V) compatible with optical Shrink Process (90%) of 0.13um Foundry General Process
- Substrate resistivity: 1kohm-cm
- Up to 1Poly 5Metal process (with UTM), 1Poly 2~3Metal + 1~2 UTM (Four configuration)
- Fully Characterized PDK and Industry Standard CAD Tools
- Inductor
 
0.13μm RF SOI CMOS
- Single (2.5V) for switch or dual gate oxide process (1.2V / 2.5V) for LNA
- Substrate: Trap-rich SOI
- Up to 1Poly 5Metal process (with UTM), 1Poly 2~3Metal + 1~2 UTM (Four configuration)
- Fully Characterized PDK and Industry Standard CAD Tools
- Inductor

문의 : sales1@dbhitek.com